FloPlast Push Fit Waste Bend Swivel - 90 Degree x 32mm Grey

Category

Soil and Waste Pushfit Waste

Store

Professional Building Supplies

Brand

FloPlast

Swivel bends are used to create a tight radius 90 degree change of direction in a waste pipe system. They are also often referred to as M and F bends or spigot bends. They have a long tail that is usually inserted into the socket of another fitting.This fitting is available in 32mm and 40mm size options.This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.Click here to read our guide that explains the key differences between push fit and solvent weld waste systems.

1.91 GBP

Recommendations

Professional Building Supplies

FloPlast Push Fit Waste Bend Swivel - 90 Degree x 32mm Grey

1.91 GBP