Kategori
Printers Scanners
Butik
Conrad Electronic
Varumärke
3Dbasics
3D-basics TPM Wash Solvent is a non-flammable, low-odor solvent used for cleaning and resolving unhardened resin in Stereolithography (SLA) 3D printed parts. 3D basics TPM Wash SolventTPM Wash Solvent (tripropylene glycol monomethyl) is a non-flammable, low-odor solvent used for cleaning and resolving unhardened resin in stereolithography (SLA) 3D-printed parts. TPM has a lower evaporation rate than IPA and TPM can wash approximately three times as many parts as IPA before it needs to be replaced.TPM is not currently certified for use with Formlabs biocompatible resins.TPM is compatible with the Finish Kit, Form Wash and Form Cure of Formlabs.ApplicationAlways wear gloves when handling TPM.To remove uncured resin from SLA or DLP printed parts, fill your cleaning vessel with the quantity specified by the manufacturer. To minimize waste, it is recommended that you clean the parts in advance before inserting them into the cleaning container to extend the life of your new TPM. This can be
114.99 GBP
≈ 1536.21 SEK
Rekommendationer
Choose your language and region
Klarna is available around the world with a variable offering, choose one that suits you best.
Copyright © 2005-2024 Klarna Bank AB (publ). Headquarters: Stockholm, Sweden. All rights reserved. Klarna Bank AB (publ). Sveavägen 46, 111 34 Stockholm. Organization number: 556737-0431