ARP Rod Bolt Kit BMW S85B50 V10 (CA625+) Material : CA625+ Part Number: 201-6002 Application: BMW 5.0L (S85) V10 Cap Screw without Washer - Rod Bolt Installation [1] Please check the part-number(s) for your application against the part-number(s) listed on the instruction sheet. [2] Make sure there is an adequate chamfer around the bolt hole on the connecting rod cap to clear the radius under the head of the bolt. [3] Lubricate the threads and the under head of the bolt with ARP Ultra-Torque Fastener Assembly Lubricant. [4] ARP recommends using the STRETCH METHOD when tightening rod bolts. Following the instructions for using a stretch gauge, Stretch the bolts to . 0075- .0080[5] If you do not have a stretch gauge, torque the bolts to: 60 ft-lbs [6] The connecting rods should always be re-sized after new rod bolts are installed. [7] A log should be kept on the original non-torqued length of each bolt. Bolts that have any permanent deformation or have increased in non-torqued length