Kestävä ratkaisu isojenkin leijabladderivikojen korjaamiseen. Sopii myös pieniin korjauksiin leijakankaassa. Sisältää: 1kpl Hot melt film (100 x 15cm) 1kpl "leivinpaperi" 2kpl alkoholipyyhkeitä Step by step procedures: HOT-MELT BLADDER REPAIR (CLEAN CUT) S1. Pre-sand the area with fine sanding paper S2. Clean the sanded area with alcohol swabs and leave to air-dry S3. Cut oversized piece of hot-melt patch and round the corners S4. Place the patch over the tear (hot-melt side facing down!) S5. Place heat shield over the patch and iron the patch for 3 - 5 seconds S6. Remove air bubbles as much as possible after 1st phase S7. Repeat ironing for 12 - 15 seconds, apply pressure HOT-MELT BLADDER REPAIR (BLOWOUT) S1. Cut off the wrinkled area (if any) S2. Pre-sand the area with fine sanding paper S3. Clean the sanded area with alcohol swabs and leave to air-dry S4. Cut 2 oversized pieces of hot-melt patch and round the corners S5. Place 1st patch inside the bladder (hot-melt side facing up!)