Without N-connection, Power MOSFET up to 200W. Standby loss of only 0.5 watts. With control inputs for light sensor and light switches Minimum brightness, operating mode and dimming speed can be set. For panel mounting. 45mm long, 45mm wide, 18mm deep. Universal dimming switch for R and C loads up to 200W, depending on the ventilation conditions. Dimmable ESL and 230V-LED lamps in the operating mode Phase section up to 200W or in the operating mode Phase section up to 40W, depending on the ventilation conditions. For dimmable 230V LED lamps, which glow slightly even when the device is switched off, a base load element BLE must be connected in parallel to the lamp. L-loads (inductive loads, e.g. wound transformers) must not be connected. Switching in zero crossing with soft-on and soft-off for lamp protection. Control voltage, supply voltage and switching voltage 230V. Minimum load 4W Short control commands switch on / off, permanent controls change the brightness up to the maximum valu