The R-M55 has been the flagship in the Baileigh Industrial roll bender line since its introduction. It has a 2" schedule 40 pipe capacity, which is impressive for a manual top shaft, two driven roll machine. To achieve this type of capacity, the R-M55 uses a variable speed inverter that is overload protected. This allows the operator to fine-tune the rolling speed for each material. \n \nThe R-M55 is very versatile, and can be used in any fabrication shop or even out in the field on job sites, as it only requires 220 volt, single phase power to operate. \n \nIt can be operated both the vertically for smaller rolling projects, as well as horizontally on its back, for large rolling projects, as there are feet on the bottom and back of the machine. \n \nThe R-M55 roll bender comes standard with foot pedal controls, segment rolls, and lateral roll guides to keep the material from twisting during the bend. The top roll position is manually controlled with the use of a large ratchet for more