These LED indicator resistors from Oberon Performance are approved for use with Oberon Performance LED indicators. The purpose of the resistor is to 'fool' the bikes original flasher relay unit by offering the same resistance as the original filament light bulb.  Simple to fit, the resistor has two wire location points and is meant to be wired in parallel. Simply meaning one end of the resistor is wired to the power lead and the other end for the ground lead (a simple diagram is included with every purchase).   Please note, this resistance will contribute to the LED indicator resistor gaining considerable heat like a light bulb. Therefore a certain amount of caution should always be applied when working with electric, even at low voltages. For best results it is always recommended that all wiring is suitably soldered and the resistor, to be mounted on a smooth metallic surface to help absorb the heat generated. It is not advised to mount the resistor on plastic or other surfaces that