The following changes have been made in the current Autodesk Inventor CAM Ultimate 2024 update: Changes for 2D Contour Fixed possible linking issues in Contour2D when input contours contain arcs with the same center. Fixed a bug when "finishing feedrate" might not apply to last finishing path. Fixed a case when Contour2D could fail to generate toolpath for narrow slots with ramp linking. Changes for Blend & Flow Fixed an issue in Flow operations where the toolpath might not be machined if the tilt angle was exceeded on a machine with limited axial motion. (#39642) Added damping for toolaxis limits in Blend and Flow with a non ball tool. When the toolaxis hits the limit, it will decelerate to a stop rather than stopping suddenly. (#40955) Fixed a possible holder gouge in Blend and Flow strategies with enabled "Trim" option in holder protection. (#42254) Fixed a failed toolpath calculation in Blend which occured in some instances where machining boundaries were used. (#41413) Fixed possi